Ceiling Panel Direction

When you are looking to install ceiling panels you will often be confronted by the choice of direction in which to run the panels.

If the room is square this is obviously not an issue but in a rectangular room there are a few issues that need to be addressed.

One customer had a room where the ceiling was 4m long but only 1m wide and wondered which way was correct - as the panels can be installed either way it's a personal taste issue rather than a right/wrong way.

If you are using a flush fitting panel, such as Labo or Blanca it is not going to make much difference as the joints are not that visible. If you are using the cladding with the infill strip or using a v-groove panel such as Topline then the direction will have more of an effect, but not a massive one.

Running the ceiling panels along the room will have the effect of making the room look longer and narrower. Running them across the room will have the effect of making the room look shorter and wider.

So it really depends which you prefer. If you do choose to opt for cutting the panels shorter you will find it is much easier to fit, cut and handle smaller lengths. Also it might well be that you will require less panelling to cover the bathroom ceiling in one direction than it will in the other.

Longer Labo Ceiling Panels Added

Labo ceiling panels are now available in a 6m length as well as 4.5m and 2.6m. This enable larger areas to be spanned without the need for joins (which are not the best looking option). They also offer another option when trying to work out the most economic way to cover a bathroom ceiling. One pack (4 panels) of the 6mt length is enough to cover a bathroom 3m x 2m or a room 1.5m x 4m.



The Labo panels can be fitted with the optional Infill Trims (extra) which helps break up the solid colour of the ceiling and provides visual interest. The panels can also be used on walls if required but the Infill Strips are not suitable for use in wet areas such as inside a shower cubicle or over a bath.

Bathroom Ceiling Panels

When wall panels are installed the weight of the panel rests on the floor, bath or shower tray so the panels are effectively just "leaning against the wall" Consequently the bond between the panel and the wall does not have to be that strong to be effective. When panels are fitted to a bathroom ceiling however the bond is much more critical.

Most filters that we have spoken to use a combination of adhesive and a staple gun. Solvent-free adhesive tends to be slightly less effective that those with solvent (if using adhesive with solvent be sure that there is plenty of ventilation when you are fitting the panels). The staples help hold the panel in place whilst the adhesive sets.

The panels that we sell are very easy to cut so we always recommend taking your time cutting them to ensure a good fit. The joint between the ceiling panels and the wall can be sealed with silicone. If you are not confident of achieving a neat cut finish you can use trims to help cover the edges of the panels. The problem with most of the trims sold by the manufacturers is that they are designed to be used with wall panels rather that ceiling panels. They can, however, be adapted for use with ceilings by trimming away the back section that would usually clip over the top of the wall panels. The trims can then be mitred and stuck up once the panels are in place. Any trim could be use for this purpose, not just the trims that we sell. Tile edge trim, quadrant or scotia moulding could be fitted once the ceiling panels are in installed.